Press

Training Week

Practical coverage of product training, operator know-how and stock handling topics for busy workshop teams.

How Training stock lands in a working week

Training Week gathers practical notes on product training, operator know-how and stock handling for workshop teams. It is intended for busy floors where better use of materials and equipment matters day to day.

Training Week starts with the machine in front of the learners, not a generic parts list. Cutter diameter, lens size, ink type, substrate thickness and shift timing change what must be on hand for a useful session. In Sunnyrock, dispatch planning also needs room for load-shedding windows, courier collections and the extra consumables that get used when operators repeat a setting more than once.

Before anyone loads material, capture the first setup photo at the machine and note the cutter, nozzle or platen in use. A small training card near the control panel helps the next operator repeat pressure, speed or heat settings without guessing. When stock gets split across shifts, that record matters more than a loose message thread.

Training stock that earns its place

The useful outcome is a session pack that matches the job mix and the operator level. Notes should cover tool or media selection, machine settings worth repeating, and the consumables most likely to run short during drills. For a busy workshop, one accurate list with the right SKU names is easier to action than several loose suggestions.

Before the session date is fixed, line up the learner count, the sample materials and the machine models in the contact form. Include any repeat fault such as poor cut edge, lens contamination, banding on DTF prints or stock damage after storage. Check labels, quantities and paperwork again before cartons move to courier handover.

  • Learner numbers matched to stock picked
  • Machine photos checked against session materials
  • Fault notes attached to the training brief

Sunnyrock stock and site conditions

Training in Johannesburg, Durban and Cape Town does not look the same once storage, moisture and power interruptions are taken into account. Coastal humidity can affect film, paper liners and some packed consumables, while inland dust reaches rails, optics and open stock fast. If the team is learning on a machine that is still producing customer work, the session plan needs to protect both output and stock control.

Older machines often need slower, more deliberate checks during instruction. Extraction performance, air assist, bed condition, pinch rollers, platen heat or chiller status can decide whether a sample run teaches the right lesson or creates confusion. Where walk-in demonstrations happen near the bay, packed stock also needs to stay clearly separated from teaching samples.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

What to send for Training Week

Send the training brief with product photos, learner numbers, dates, and any materials or consumables that already caused problems. Keep the subject line clear.

Add the machine type, any settings that keep drifting, and whether samples must be produced during the session. That record helps procurement, stores and operators work from the same information after the training date passes.